Support
Wall Lights

Tabs

Read Article

The recessed fixtures include a Schedule 40 conduit. This conduit can be cut to length but must always fully capture the fixture base. It cannot be cut any shorter than 7–1/2". Follow the step-by-step instructions below to install these lights.

Model	Sleeve P/N	SCH 40 Size	Pipe OD	Recommended Core Drill Size
PO	250018590000	1-1/2"	1.9"	2"
VO	C2165	N/A	1.78" (custom)	2"
MO	25002060000	2"	2.36"	2-1/2"
CG	250013670000	2"	2.375"	2-1/2"
CN-51	N/A	2-1/2"	2.875"	3"

Step 1

Use the provided conduit and trim length if necessary.

Step 2

Install conduit sleeve into wall during construction. Run fixture wiring through sleeve. *Coupling for VO fixture only.

Step 3

Use voltmeter to ensure 11 to 15 V at fixture.

Step 4

Connect wiring with waterproof connector.

Step 5

Press faceplate into sleeve. Level and orient fixture as desired.

Step 6

* For the concrete ground-mount option, use construction housing. The VO-ST is rated for a load of 992 lbs.

Rate this Article:

No votes yet

SupportWall Lights

MO, PO, VO, CG, & CN