Locate transformer(s) in a well ventilated area away from direct irrigation spray and central to where the majority of the lighting fixtures will be installed. The goal is to minimize the length of cable runs from your transformer to the lighting fixtures thus minimizing voltage drop and cable size.
Transformer(s) with power cords must be located adjacent to a 120 volt GFCI protected exterior electrical receptacle. If a 120 volt power source is not available at the desired transformer installation location, it is advised that you hire a licensed electrician to run a dedicated 120 volt, 15 amp circuit to the desired location.
Test all existing receptacles with both a receptacle tester and a digital voltmeter or amp clamp to verify proper wiring and voltage at the receptacle.
SINGLE TRANSFORMER
When using only one transformer, it is very important to center the transformer on the wattage load. If the project calls for 135 watts in both front and back yard, the PX-300 or PX-600 should be centered on the side of the house that will receive the most T lighting. A common mistake is to locate the single transformer on the service side of the house or in the garage, which might result in excessively long cable runs to reach lighted areas. The primary goal in laying out low voltage systems is to minimize cable runs because of the negative effect voltage drop has on lamp output performance.
MULTIPLE TRANSFORMERS
A common mistake in laying out multiple transformer circuits is to group several transformers in one location because of utility or visual considerations only. As with any low voltage layout, the prime directive should be to locate the transformers as close to the fixtures as possible in order to minimize cable runs and resulting voltage drop. The other multi-transformer layout consideration is “use zoning.” Having several transformers allows the client to selectively control light in separate areas. This approach is similar to irrigation design in that the goal is to individually control areas that have similar needs. In lighting, a recreation area has different lighting needs than front entry. Therefore, the lights that serve these different lighting use areas need to be on separate transformers and switch controls.
![](https://www.fxl.com/sites/fxl.com/files/sample-transformer-diagram.gif)
Sample diagram of home with transformer and lamp placement