M-PL - LED Board Replacement

Tabs

Read Article

Tools Required:

#2 Philips screwdriver
5/64” Allen Key
Soft-edged pry device (e.g., small flathead screwdriver)
Needle-Nose pliers

Installation

Step 1

Turn off power to the fixture completely before disassembling.

Step 2

Remove the four 6-32 x ½" screws (PN 750114) from the faceplate with a #2 Phillips screwdriver.

Step 3

The top LED holder will drop straight down for LED board access.

Step 4

Remove the strain relief connector with a pair of needle-nose pliers.

Step 5

Push socket end approximately ¼" backward to allow room for LED board removal.

Step 6

Once the LED board is successfully removed, perform this procedure backward to reinstall the replacement LED board. Not all boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also, remove any residue left on the fixture from the old LED board prior to installation of the new one. A pink-colored thermal pad is attached to the bottom of all FX Luminaire LED boards and should be left in place. Compatible LED boards for this fixture include: ZDCKITR (color), 755901 (ZD), and 755902 (standard).

If using the LUXOR controller and currently have group numbers assigned, the new LED board will have to be assigned a group number. There are two options:
1. If you have a Wi-Fi module installed and the LAM (Light Assignment Module accessory), the LED board can easily be assigned a group number with the fixture installed. Learn more
2. If you do not have a LAM, you can bring the fixture back to the Luxor to program the group number. Learn More

Find an authorized FX Luminaire distributor near you using our interactive Distributor Lookup.

Rate this Article:

No votes yet

SupportPath Lights