Filter

Support
Luxor CUBE

CUBE Models

Tabs

Read Article
Luxor CUBE

The Luxor CUBE allows the Luxor to control, zone, and dim lighting fixtures and other devices that don’t have built-in FX technology. Install the CUBE in-line prior to the fixtures or devices you wish to control as a zone. When that zone (Group) is activated by the Luxor, the light on the Cube LED will illuminate along with all fixtures/devices inline and will initiate/dim according to the commands of the Luxor.

Three Luxor CUBE Models available:
Low Voltage (LCM-LV)
  • Add zoning and dimming to AC dimmable LEDs (Diagram A)
  • Luxor will power the dimmable LEDs, but an alternate power source is required for incandescent lamps (Diagram B)
  • Do not exceed 60 watts
  • In/Out Voltage - The voltage coming in is the same voltage on the output side (e.g.,15 VAC in - 15 VAC Out).

CAUTION

  • Attach only lamps to the output of the LV CUBE.
  • Attach only dimmable lamps to the output.
  • Do not use the LUXOR as both power and control if an incandescent fixture is attached to the CUBE's output.
  • Do not apply more than 15VAC to the input power leads.
  • Do not attach more than 60W of lamps to the output of the LV CUBE.
  • Use only watertight connectors in wet environments.
High Voltage (LCM- HV)
  • Add zoning and dimming to incandescent and AC dimmable LED fixtures.
  • Do not exceed 400 watts

CAUTION

  • Attach only lamps to the output of the HV CUBE (no motors, transformers or other non-lamp loads).
  • Do not attach the output of the HV CUBE to a non-dimmable lamp.
  • Do not attach more than 400watts of lamps to the output.
  • Do not short the output.
  • Use only forward phase-cut dimmable lamps.
  • Do not apply 230 ,240, or 277VAC to the input.
  • Do not install the CUBE such that its output is connected to a standard wall outlet.
  • Do not forget to attached the green wire to ground.
  • Install inside a junction box according to NEC guidelines.
Relay and 0-10V (LCM-RLY-010V)
  • Control via relay or 0-10V dimming

CAUTION

  • Do not attach the 0-10V output of the CUBE to anything except a 0-10V input dimmable power supply.
  • Do not use to switch a load greater than 250VAC.
  • Do not use to switch a load greater than 5A.
  • Do not use to switch a load that requires a horsepower-rated relay.
Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No