Caution and Safety Instructions
- Qualified personnel must install and/or service product in a manner consistent with its intended use and in compliance with the National Electrical Code, Canadian Electrical Code, and/or all local and provincial codes.
- Follow all product label information and installation instructions.
- Turn off power at fuse or circuit breaker before installation or servicing.
- The use of damaged components may cause an unsafe condition and void product warranty.
- Do not block light emanating from product in whole or part.
- Never operate the luminaire with missing or damaged lens. Clean lens on a regular basis.
- Entire luminaire may become extremely hot. Do not touch hot lens or luminaire body. Do not touch the light source at any time.
- Keep all O-rings and sealing surfaces clean during installation and servicing; failure to do this may lead to premature failure of the product.
Unfasten the 8-32 x 7/ 16" (11 mm) screw with a 9/64" Allen key. Remove the cap by lifting outward. To protect the powder coat finish, avoid using metal tools.
Lift the cartridge arm and turn it counterclockwise to release the lock. Pull the complete cartridge out of the fixture housing.
Rotate the cartridge arm back into the neutral position. Twist the optic counterclockwise and pull outward to remove.
Use a #2 Phillips screwdriver to unfasten one screw inside the cartridge.
Twist and agitate the upper cartridge component to remove the top portion.
Use a #1 Phillips screwdriver to unfasten the three LED module screws. Remove the reflector adapter ring and LED module from the cartridge platform.
Use a #2 Phillips screwdriver to remove the driver clamp.
Push the black, six-pin connector downward to unlock it from the cartridge.
Remove the driver from the cartridge.
Very Wide and Wall Wash Options
Disassemble the fixture by following steps 1 and 2 in the previous section.
Use a #2 Phillips screwdriver to unfasten one screw inside the cartridge.
Twist and agitate the upper cartridge component to remove the top portion.
Remove the reflector from the LED module by carefully inserting a precision slotted screwdriver between the module and the reflector and lifting outward. Repeat in a circular manner around the base of the reflector until the reflector is disconnected.
Use a #1 Phillips screwdriver to unfasten the three LED module screws. Remove the reflector adapter ring and LED module from the cartridge platform.
Remove the driver clamp using a #2 Phillips screwdriver.
Push the black, six-pin connector downward to unlock it from the cartridge.
Remove the driver from the cartridge.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.