Caution and Safety Instructions
- Qualified personnel must install and/or service product in a manner consistent with its intended use and in compliance with the National Electrical Code, Canadian Electrical Code, and/or all local and provincial codes.
- Follow all product label information and installation instructions.
- Turn off power at fuse or circuit breaker before installation or servicing.
- The use of damaged components may cause an unsafe condition and void product warranty.
- Do not block light emanating from product in whole or part.
- Never operate the luminaire with missing or damaged lens. Clean lens on a regular basis.
- Entire luminaire may become extremely hot. Do not touch hot lens or luminaire body. Do not touch the light source at any time.
- Keep all O-rings and sealing surfaces clean during installation and servicing; failure to do this may lead to premature failure of the product.
Step 1
Remove the cap by unfastening the 6-32 x 1/ 2" (13 mm) screw using a 7/64" Allen key. Then lift the cap outward. Avoid using metal tools while lifting the cap to protect the power coat finish.
Step 2
Twist the reflector optic counterclockwise and pull outward to remove.
Step 3
Unfasten the three LED module screws using a Phillips #1 screwdriver. Remove the reflector adapter ring and LED module.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.