Filter

Support
Line-Voltage Lights

A-KN - Installation

Tabs

Read Article

Caution and Safety Instructions

  • Qualified personnel must install and/or service product in a manner consistent with its intended use and in compliance with the National Electrical Code, Canadian Electrical Code, and/or all local and provincial codes.
  • Follow all product label information and installation instructions.
  • Turn off power at fuse or circuit breaker before installation or servicing.
  • The use of damaged components may cause an unsafe condition and void product warranty.
  • Do not block light emanating from product in whole or part.
  • Never operate the luminaire with missing or damaged lens. Clean lens on a regular basis.
  • Entire luminaire may become extremely hot. Do not touch hot lens or luminaire body. Do not touch the light source at any time.
  • Keep all O-rings and sealing surfaces clean during installation and servicing; failure to do this may lead to premature failure of the product.
  • For installation in pedestrian and pedal cycle restricted areas.
  • Looping connection limited to 24W.
  • Basic insulation is provided between dimming input and mains input.
  • Caution, risk of electric shock.
  • FAQ, Installation, Programming
Step 1

Excavate a 20" (508 mm) diameter hole in the desired location.

Step 2

Run conduit or cabling at least 3" (76 mm) deeper than the bottom of the construction sleeve (“sleeve”).

Step 3

Choose the ideal knockout(s) to attach conduit or install cabling and use a tool of choice to forcefully remove the knockout.

Step 4

For conduit, connect to sleeve with couplings of choice (½"-14 NPT). For cabling, install with cord glands and torque to 50 in-lbs (5.6 Nm).

Step 5

Remove the wiring compartment cover and pull the wiring into the sleeve. Leave the cover inside the sleeve to prevent loss.

Step 6

Add installation cover onto sleeve using the provided fasteners.

Step 7

Insert a piece of 2" x 4" (50 mm x 100 mm) lumber with a length in excess of the excavated area into the cover’s slot. Secure with metal fasteners (not provided).

Step 8

Build a wooden frame to align and secure the construction sleeve during the concrete pour.

Step 9

Ensure the wooden frame aligns the top of the cover with grade for a flush installation. To install the faceplate slightly above grade, raise the frame no more than ⅜" (10 mm).

Step 10

Fill hole with gravel ½" (13 mm) higher than the lower drainage ledge.

Step 11

Pour concrete up to grade.

Step 12

Following sufficient concrete hardening (curing), remove wood frame and installation cover.

Step 13

Run incoming wiring from luminaire housing through the wiring compartment cover. Connect wiring using the wiring diagram and approved wire connectors.

Step 14

Seal wiring compartment with cover by pressing in place completely.

Step 15

Place the housing inside the sleeve and rotate according to the proposed directional of light.

Step 16

Insert four screws (included) to secure in desired position with an installation torque value of 50 in-lbs (5.6 Nm).

Step 17

Using a #2 Phillips screwdriver, turn the top adjustment screw to adjust the direction (or angle) of the LED cartridge. One full turn = 1º. Use a torque value less than 50 in-lbs (5.6 Nm).

Step 18

Attach the faceplate and fasten the screws to secure.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No