Install construction sleeve (“sleeve”) inside the wall using provided L-brackets, mounting to structural supports (e.g., 2"x4" (50 mm x 100 mm) framing studs). For lighting in the downward direction, ensure the arrow in the sleeve is pointing upward.
Run conduit and/or wiring (code dependent) to the ideal “knockout(s)” in the construction sleeve.
Use a tool of choice to forcefully remove the knockout.
Connect the conduit/wire runs to the sleeve with couplings of choice (1/2"-14 NPT).
Attach the sleeve cover to protect the interior during wall finishing using included fasteners.
Remove the sleeve cover to resume installation.
Connect wiring from housing assembly to the incoming power lines using the wiring diagram (see previous section) and approved wire connectors.
Insert the complete housing assembly into the construction sleeve.
Place the housing inside the sleeve and fasten the screws through the center slots on the left and right sides. Before fully tightening, rotate the housing according to the level for ideal installation.
Use the included fasteners to attach the faceplate to the housing.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.