Caution and Safety Instructions
- Qualified personnel must install and/or service product in a manner consistent with its intended use and in compliance with the National Electrical Code, Canadian Electrical Code, and/or all local and provincial codes.
- Follow all product label information and installation instructions.
- Turn off power at fuse or circuit breaker before installation or servicing.
- The use of damaged components may cause an unsafe condition and void product warranty.
- Do not block light emanating from product in whole or part.
- Never operate the luminaire with missing or damaged lens. Clean lens on a regular basis.
- Entire luminaire may become extremely hot. Do not touch hot lens or luminaire body. Do not touch the light source at any time.
- Keep all O-rings and sealing surfaces clean during installation and servicing; failure to do this may lead to premature failure of the product.
- For installation in pedestrian and pedal cycle restricted areas.
- Looping connection limited to 24W.
- Basic insulation is provided between dimming input and mains input.
- Caution, risk of electric shock.
The “non-user replaceable light source” must be serviced by Hunter-qualified personnel in a manner consistent with its intended use and in compliance with all local and provincial codes. Unfasten faceplate and housing screws, using a ⅛" Allen key. Remove by lifting cap upward. Avoid using metal tools to protect the powder coat finish.
Lift cartridge arm and turn counterclockwise to release lock. Pull complete cartridge out of luminaire housing.
Rotate cartridge arm back into the neutral position. Twist the optic counterclockwise and pull outward to remove the optic.
Use a #2 Phillips screwdriver to unfasten one screw inside the cartridge.
Twist and rock the upper cartridge component to the remove top portion.
Unfasten three LED module screws using #1 Phillips screwdriver. Remove reflector adapter ring and LED module from cartridge platform.
Use a #2 Phillips screwdriver to remove the driver clamp.
Push the black, six-pin connector downward to unlock it from the cartridge.
Remove the driver from the cartridge.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.