Tools Required:
- #2 Phillips screwdriver
- Soft-edged pry device (e.g., small flathead screwdriver)
XN - LED Board Identification Chart
| Description | Catalog # | |
|---|---|---|
| LED Board, H1, Warm 2,700K | KITH1W |
|
| LED Board, H1, Soft 3,000K | KITH1S | |
| LED Board, Zone/Dim, H1, Warm 2,700K | KITZDH1W |
|
| LED Board, Zone/Dim, H1, Soft 3,000K | KITZDH1S | |
| LED Board, ZDC, 6 LED | KITZDC6 | |
| Assembly, Optics, H1, Beam Angle | KITOPXA70H1YY | |
| Assembly, Optics, ZDC | KITOPXA70ZDC |
Zoning, Zone/Dim, and ZDC boards are not interchangeable on the same fixture. The driver is permanently potted inside the fixture body, preventing it from being replaced with a different LED board (Zone, Zone/Dim, or ZDC).
Turn Off power to the fixture completely before disassembling.
Remove the four screws to access the internal components. Remove Faceplate and Lens assembly.
Remove the Cap by pulling it upward.
Remove the Filter by lifting the reflector upward.
Remove the three Screws holding the reflector and LED board in place. Remove the reflector.
The LED board can now be removed. Using a small, soft-edged pry device, gently pry up on one side of the board. Ensure the base of the reflector where the LED was removed is clear of debris or residual thermal pad material.
Once the LED board is successfully removed, perform this procedure in reverse to install the replacement board. Not all the boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also remove any residue left on the fixture from old LED board prior to installation of the new one. All the FX Luminaire LED boards come with a pink thermal pad attached to the bottom that should be left in place.
Group programming must be performed using the wires at the base of the module while the LED board is installed. Insert the two wires into the Luxor programming ports, then assign the appropriate group number.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.