The Concrete Pour Kit (CPK-T6X) is used to prepare the TN-60 and TG-60 lighting fixtures for installation in concrete pours.
Tools Required: 3⁄32" Allen key, wire splice kit, and a torpedo level.
Position the collar so its top edge is level with the surface where the concrete will be poured.
Route the low-voltage wire through the ½"-inch or ¾"-inch knockout, leaving enough slack for the fixture splice. Conduit may be used but is optional.
Remove the Collet and discard it.
Use a voltmeter to ensure 11-15 V at the fixture. Connect the wiring with a waterproof connector.
Insert the fixture to align with the screw holes.
Using the screws included with the fixture, then thread them on by hand halfway.
Rotate the fixture until it is in the desired location.
Once in the desired location, tighten the screws.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.