Tools Required:
- #2 Phillips screwdriver
- Soft-edged pry device (e.g., small flathead screwdriver)
XA - LED Board Replacement:
| Description | Catalog # |
|---|---|
| LED Board, H1, Warm 2,700K | KITH1W |
| LED Board, H1, Soft 3,000K | KITH1S |
| LED Board, Zone/Dim, H1, Warm 2,700K | KITZDH1W |
| LED Board, Zone/Dim, H1, Soft 3,000K | KITZDH1S |
| LED Board, ZDC, 6 LED | KITZDC6 |
Zoning, Zoning/Dim, and ZDC boards are not interchangeable on the same fixture.
Turn Off power to the fixture completely before disassembling.
Remove the Shroud with lens assembly by twisting counter-clockwise, and lifting upward.
Remove any Filters by turning the counter-clockwise and lifting them off the reflector.
Remove the three Screws holding the reflector and LED board in place. Remove the reflector.
The LED board can now be removed. Using a small, soft-edged pry device, gently pry up on one side of the board. Ensure the base of the reflector where the LED was removed is clear of debris or residual thermal pad material.
Once the LED board is successfully removed, perform this procedure in reverse to install the replacement board. Not all the boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also, remove any residue left on the fixture from old LED board prior to installation of the new one. All the FX Luminaire LED boards come with a pink thermal pad attached to the bottom that should be left in place.
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.