The chart below will assist you in identifying different troubleshooting scenarios when using the Wireless Linking modules with the Luxor Controller.
| Issue | Symptom | Solution |
|---|---|---|
| Low Signal Strength | LSAT(s) continually drop off at random times. Random = Weekly, Daily, Hourly, and Minute. The signal strength on the LINKMOD is consistently below 70. | Remote mount LINKMOD closer to Primary LINKMOD. |
| Interference | LSAT(s) continually drop off at random times. Random = Weekly, Daily, Hourly, and Minute. Signal strength randomly jumps from high to low, including a blank (- -) screen. | Remotely mount the LINKMOD until the signal strength reading is consistent. Note: This could be a matter of inches or feet. Keep Linkmod plugged in so you can see the readings visually. |
| System Crosstalk | LSAT(s) dropping OFF after a few minutes or not turning ON. Master LINKMOD displays signal strength because it may receive a signal from a nearby system that is programmed to the same wireless channel and network ID. | Reprogram system LINKMODs to different wireless channels and network IDs. LINKMODs are preprogrammed to 0, 125, and 10, so everything is "plug and play." However, if a nearby Luxor system performs "plug and play,” then the settings are the same and will cause crosstalk. |
Still need help? We're here.
Tell us what you need support with and we'll find the best solution for you.