Luxor - Programming Module for LSAT Controller

Tabs

Read Article

Before programming, determine which module will be installed on the primary Luxor Controller (LUX models) and which will be installed on the Luxor Satellite Controllers (LSAT models). Primary Luxor Controllers are those with facepacks installed.

FAQ, Installation, Programming

Step 1

Insert the Wireless Linking Module (LINK-MOD in the U.S. and Canada or LINK-MOD-E internationally) into either of the primary Luxor Controller linking ports.

Step 2

From the Home screen, use the scroll wheel to select Setup.

Step 3

Within the Setup screen, use the scroll wheel to select Linking.

Step 4

Scroll to the Chassis Number field and select the desired Chassis Number (1–10). Each chassis on-site requires a separate number. Note: The number 0 is assigned to the Wireless Linking Module used on the primary Luxor Controller with facepack.

NOTE: Up to 5 more can be added but the facepack will not allow numbers 11-15 to be assigned. Additional chassis (11-15) can be assigned as repeat numbers (e.i., #11 can be assigned to #10).

Step 5

Scroll to the Network ID field and select the desired Network ID (0–255). The Network ID will need to be configured the same on all Wireless Linking Modules installed on-site.

Step 6

Scroll to the Wireless Channel field and select the desired Wireless Channel (1–10). The channel will need to be configured the same on all Wireless Linking Modules installed on-site.

Step 7

Scroll to Program and press the scroll wheel.

Step 8

Assignment Succeeded will appear at the bottom of the screen. If the assignment fails, repeat the process.

Install the programmed LINK-MOD or LINK-MOD-E into the desired satellite controller(s).

Next Article > Installation

Rate this Article:

No votes yet

SupportLuxor Linking