Filter

Support
Specialty Lights

Changing the LED Board on the LP Underwater Light

Tabs

Read Article

Tools Required:

  • #2 Philips screwdriver
  • 5/64” Allen Key
  • T15 Torx screwdriver
  • Soft-edged pry device (e.g., small flathead screwdriver)
  • FAQ, Installation

Step 1

Turn off power to the fixture completely before changing the LED board in any fixture.

Step 2

Remove the fixture from the support base by pulling upward.

Step 3

Using a T15 Torx screwdriver, remove the four screws from underneath the rim of the lens cap.

 

 

Step 4

With the lens cap detached,  remove the color filter to access the LED board.  For ZDC models, remove the diffuser by twisting the lens 1/4 turn counterclockwise to release the bayonet lock and lift the lens off.

Step 5

Remove the two Phillips screws holding the LED board to the fixture.

Step 6

Use a small soft-edged device to gently pry up one side of the LED board and remove it.

Step 7

Once the LED board is successfully removed, perform this procedure backwards to install the replacement board. Not all boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also remove any residue left on the fixture from old LED board prior to installation of new one. All FX LED boards come with a pink colored thermal pad attached to the bottom that should be left in place.

If using the LUXOR controller and currently have group numbers assigned, the new LED board will have to be assigned a group number. There are two options:
1. If you have a Wi-Fi module installed and the LAM (Light Assignment Module accessory), the LED board can easily be assigned a group number with the fixture installed. Learn more
2. If you do not have a LAM, you can bring the fixture back to the Luxor to program the group number. Learn More

Find an authorized FX Luminaire distributor near you using our interactive Distributor Lookup.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No